1991 Chevrolet Camaro

CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS A...

Fix: HONEYWELL WILL REPLACE THE AFFECTED OIL FILTERS FREE OF CHARGE. THE RECALL BEGAN DURING NOVEMBER 2007. OWNERS CAN CONTACT FRAM CUSTOMER SERVICE TOLL-FREE AT 1-800-890-2075.

CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2...

Fix: HONEYWELL WILL NOTIFY OWNERS AND REPLACE THE FUEL FILTERS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 18, 2006. OWNERS MAY CONTACT FRAM CUSTOMER SERVICE AT 1-800-890-2075 (OPTION...

CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL...

Fix: PRO-A MOTORS WILL NOTIFY OWNERS AND OFFER TO REPURCHASE THE LAMPS. THE RECALL BEGAN ON APRIL 3, 2006. OWNERS MAY CONTACT PRO-A MOTORS AT 323-838-2988.

THE FUEL FILLER NECK SOLDER JOINT CAN DEVELOP CRACKS OR PIN HOLE LEAKS, WHICH DOES NOT COMPLY WITH FMVSS NO. 301, "FUEL SYSTEM INTEGRITY." THE CRACKS AND HOLES CAN ALLOW FUEL VAPOR AND FUEL LEAKAGE.

Fix: DEALERS WILL INSPECT THE FUEL TANK ASSEMBLY AND REPLACE THOSE WHICH EXHIBIT THE CRACKS OR PIN HOLE LEAKS.

THE FRONT SEAT UPPER HINGE COVER SCREWS ARE TOO LONG, AND INTERFERE WITH THE SEAT BACK INERTIA LOCK. THIS PREVENTS THE SEAT BACK FROM LOCKING PROPERLY.

Fix: REPLACE SCREWS SECURING UPPER HINGE TRIM COVER WITH CORRECT LENGTH SCREWS.

THE METAL LATCHPLATES MAY NOT ENGAGE THE BUCKLE ASSEMBLIES, CAUSING A "NO LATCH" CONDITION. MOVEMENT OF THE SEAT OCCUPANT IN THIS CONDITION COULD CAUSE LATCHPLATE RELEASE FROM THE BUCKLE.

Fix: REPLACE THE RETRACTOR ASSEMBLY FOR THE SAFETY BELT (FRONT AND REAR IN COUPES AND FRONT ONLY IN CONVERTIBLES).

POOR BOND ADHESION BETWEEN THE WINDSHIELD GLASS AND THE MOUNTING, WHICH COULD ALLOW THE WINDSHIELD TO SEPARATE FROM THE VEHICLE DURING A COLLISION. THIS FAILS TO CONFORM WITH FMVSS 212.

Fix: REMOVE ALL SEALER FROM WINDSHIELD AND MOUNTING; APPLY NEW BONDING AND SEALANT MATERIAL, AND REINSTALL WINDSHIELD.